Financial binding machine is not hot riveting or pressure riveting fault solution.

At present, any brand of riveting tube binding machine on the market is completed by "punching" and "riveting". We often encounter the problem of poor riveting during use. Today, I have sorted out a relatively complete list of the failure causes and solutions that lead to poor pressure riveting, which is also useful for Yongchuangeng binding machine and other brands of binding machines.

Financial binding machine

Problem 1: The machine always displays the preheating state when the power switch is turned on, and the riveting head cannot complete the riveting action without preheating.

Reason: It may be a machine wiring problem or a machine motherboard problem.

Solution:

Check whether the wire connecting the riveting head to the circuit board is loose, and fix the connecting wire again.

If there is no problem with the line, it may be a motherboard problem, and the binding machine motherboard needs to be replaced.

Problem two: machine riveting riveting head melting, can not form a rivet effect

Cause: riveting head temperature is too high

Solution: adjust the riveting head temperature, or replace the motherboard

Problem three: pressure riveting effect is not good, or one side is not pressure riveting

Solution:

The upper riveting head is damaged by the positioning needle, and the upper riveting head needs to be replaced.

There is no temperature in the upper riveting head. It is possible that the heating plate has a problem and needs a heating plate.

The lower riveting head does not press riveting, check whether there is residual pipe in the lower riveting head, and clean up the residual pipe for normal use. If the lower riveting head has no temperature, the lower heating plate may have problems and need to replace the riveting head.

More news

■

How do financial personnel choose a suitable voucher binding machine?

—

2024-04-18